Latest 200-355 Exam Dumps

Question No. 1

You are configuring an IP address on an autonomous access point. Which interface do you use to configure the IP address?

• A. BVI1
• B. FastEthernet 0
• C. Dot11Radio0
• D. VLAN 1

Question No. 2

What authentication method requires a certificate on both the client and authentication server?

• A. PEAP
• B. EAP-TLS
• C. EAP-FAST
• D. WPA-PSK
• E. WEP
• F. EAP-TTLS

Question No. 3

Which device divides a signal between two antennas?

• A. splitter
• B. lightening arrestor
• C. attenuator
• D. amplifier

Question No. 4

Which statement best describes the ability of a wireless client to access and transmit a data frame to an AP?

• A. The client listens to the media until polled by the AP using PCF to send its data.
• B. The client listens to the media until a data frame is finished, at which time it transmits, unless a collision of data frames has occurred.
• C. The client uses random countdown timers to start the transmission of a data frame.
• D. The client listens to the media and countdown timers to start the transmission of a data frame.

Question No. 5

What is an encrypted WLC management protocol?

• A. SNMPv2c
• B. SNMPv2
• C. SNMPv3
• D. SNMPv1

Question No. 6

Which description of the procedure for a lightweight AP to successfully establish a connection to a controller is true?

• A. The AP sends its certificate to the RADIUS server. The AP then authenticates the controller certificate as valid.
• B. The AP sends its certificate to the RADIUS server. The AP then authenticates the RADIUS certificate as valid.
• C. The AP authenticates the received Cisco WLC certificate as valid. The AP then sends its certificate to the controller.
• D. The AP sends its certificate to the controller. The AP then authenticates the received Cisco WLC certificate as valid.

Question No. 7

Which protocol must be negotiated for client to obtain IP address configuration?

• A. DHCP
• B. RADIUS
• C. DNS
• D. NTP

Question No. 8

Which action secures the SNMPv2C protocol in a Cisco WLC?

• A. configure new communities and disable default communities
• B. use digital certificates to authenticate and encrypt transmissions
• C. enable password or transfer encryption
• D. set a username and difficult-to-guess password

Question No. 9

Which three access point modes service clients? (Choose three.)

• A. FlexConnect
• B. bridge
• C. sniffer
• D. local
• E. monitor
• F. SE-Connect

Question No. 10

Which two statements about the results of the Cisco WCS version 7.0 client troubleshooting tool are true? (Choose two.)

• A. Results of Layers 1 – 3 are provided.
• B. Results of only Layers 2 and 3 are provided.
• C. Results of Layers 4 – 7 are provided.
• D. The tabulated results vary depending on the client type.
• E. Results are provided in a fixed four-part tabulation.
• F. Results are provided in a fixed six-part tabulation.