Free Juniper JN0-661 Exam Dumps – [Feb-2018 Dumps]

By | February 27, 2018

Success in Juniper Service Provider Routing and Switching JN0-661 exam with the all-inclusive Juniper JN0-661 exam dumps preparation material is offered with money back guarantee so either you embrace the success or get your money back because your success is the central focus. JN0-661 exam practice test software is designed in a way that it gives you a chance of getting a clear picture of whole syllabus, exam pattern, practice of exam in simulated real exam scenarios and more than all evaluation of your learning independently with self-assessment feature.

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

You are deploying a next-generation multicast VPN in your network and must identify which routers require tunnel services?

A. DRs closest to the receiver require tunnel services.
B. DRs closest to the source require tunnel services.
C. All MVPN PE routers require tunnel services.
D. All MVPN P routers require tunnel services.

Answer: C

Question: 22

Refer to the exhibit.

You have the Layer 2 VPN configuration shown in the exhibit. You have been asked to determine the remote site ID for ge-1/0/4.512. What is the remote site ID?

A. 1
B. 3
C. 4
D. unspecified

Answer: A

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group and R4 for all other groups
C. R1 for all groups
D. R4 for group and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: