Free Cisco 642-887 Exam Dumps – [Feb-2018 Dumps]

By | February 2, 2018

Success in Cisco Certified Network Professional Service Provider 642-887 exam with the all-inclusive Cisco 642-887 exam dumps preparation material is offered with money back guarantee so either you embrace the success or get your money back because your success is the central focus. 642-887 exam practice test software is designed in a way that it gives you a chance of getting a clear picture of whole syllabus, exam pattern, practice of exam in simulated real exam scenarios and more than all evaluation of your learning independently with self-assessment feature.

♥♥ 2018 NEW RECOMMEND 642-887 Exam Questions ♥♥

642-887 exam questions, 642-887 PDF dumps; 642-887 exam dumps:: https://www.dumpsschool.com/642-887-exam-dumps.html (130 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 642-887 Dumps Exam Questions and Answers:

Question: 21

From PE8 router, what is the label action used to reach the P2 loopback 0 interface 10.0.2.1/32?

A. Swap label 35 with label 16004
B. Push label 16004
C. Pop label 35
D. Pop label 16009
E. Push Label 16009
F. Swap label 35 with label 16009

Answer: C

show mpls forwarding-table , find prefix 10.0.2.1 and you will see there under outgoing Label “Pop Label” (This is actually logic because the prefix is directly connected and therefore the packet will forward without label). If the router should forward any packet to that prefix, the packet should be received with Local label on PE8 (Local Label = 35), the router will remove it and forward it without Label.

Question: 22

From the PE8 router, how many total prefixes for have an incoming local label assigned (including the imp-null)?

A. 45
B. 21
C. 66
D. 22

Answer: B

Question: 23

DS-TE implementations on Cisco routers support which bandwidth pool(s) and class type(s)? (Choose two.)

A. global pool only
B. subpool only
C. global pool and subpool
D. class-type 0 only
E. class-type 1 only
F. class-type 0 and class-type 1

Answer: C, F

Explanation:
Differential Service Tunnels
Differential Service Traffic Engineering (TE) is an extension of the regular MPLS Traffic Engineering (MPLSTE) feature. Regular TE does not provide bandwidth guarantees to different traffic classes. A single bandwidth pool (global pool) is used in regular TE that is shared by all traffic. In order to support various class of service (CoS), the ability to provide multiple bandwidth pools is required. These bandwidth pools then can be treated differently based on the requirement for the traffic class using that pool.
In RSVP global and subpools reservable bandwidths are configured on a per interface basis to accommodate TE tunnels on the node. Available bandwidth from all configured bandwidth pools is advertised using Interior Gateway Protocol (IGP). RSVP is used to signal the TE tunnel with appropriate bandwidth pool requirements.

Question: 24

Which field in the MPLS shim header is used to support different QoS markings?

A. IP precedence
B. DSCP
C. EXP
D. ToS
E. S
F. Label

Answer: C

Explanation:
MPLS EXP Marking
The three MPLS EXP (experimental) bits in the shim header of an input or output MPLS packet header may be set or changed by a user configured value

Question: 25

On a Cisco IOS XR router, which mechanism protects the router resources by filtering and policing the packets flows that are destined to the router that is based on defined flow-type rates?

A. LLQ
B. LPTS
C. Committed Access Rate
D. Control Plane Policing
E. Management Plane Protection
F. NetFlow
G: ACL

Answer: B

Explanation:
Local Packet Transport Services (LPTS) maintains tables describing all packet flows destined for the secure domain router (SDR), making sure that packets are delivered to their intended destinations.
The Low Latency Queueing feature brings strict priority queueing to Class-Based Weighted Fair Queueing (CBWFQ).

Question: 26

When configuring LLQ (strict priority queue) on a traffic class using the Cisco IOS XR priority command on a Cisco ASR9K router, which additional QoS command is required for this traffic class?

A. shape
B. police
C. random-detect
D. bandwidth

Answer: B

Explanation:
The Low Latency Queueing feature brings strict priority queueing to Class-Based Weighted Fair Queueing (CBWFQ).

New Updated 642-887 Exam Questions 642-887 PDF dumps 642-887 practice exam dumps: https://www.dumpsschool.com/642-887-exam-dumps.html

         

Facebook Comments