Free Cisco 200-355 Exam Dumps – [Jan-2018 Dumps]

By | January 23, 2018

Success in Cisco Certified Network Associate Wireless 200-355 exam with the all-inclusive Cisco 200-355 exam dumps preparation material is offered with money back guarantee so either you embrace the success or get your money back because your success is the central focus. 200-355 exam practice test software is designed in a way that it gives you a chance of getting a clear picture of whole syllabus, exam pattern, practice of exam in simulated real exam scenarios and more than all evaluation of your learning independently with self-assessment feature.

♥♥ 2018 NEW RECOMMEND 200-355 Exam Questions ♥♥

200-355 exam questions, 200-355 PDF dumps; 200-355 exam dumps:: (420 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 200-355 Dumps Exam Questions and Answers:

Version: 10.0
Question: 21

Which four options are the characteristics of the original 802.11 protocol? (Choose four.)

A. Defined DSSS and FHSS as possible methods for modulation
B. Designed to operate in the 5 GHz ISM frequency spectrum
C. The most common deployment is three non-overlapping channels that are 20 MHz wide
D. The protocol sets the maximum throughput at 1 Mb/s or 2 Mb/s
E. Defined FHSS and OFDM as possible methods for modulation
F. The most common deployment is three non-overlapping channels that are 22 MHz wide
G. Designed to operate in the 2.4 GHz ISM frequency spectrum
H. The protocol sets the maximum throughput at 1 Mb/s

Answer: A, D, G, F

Question: 22

The network administrator receives complaints of slow wireless network performance and performs a sniffer trace of the wireless network in preparation for migration to 802.11n. The sample capture shows frames that contains AP beacons with NonERP_Present bit set to 1 and frames with RTS/CTS.
Which two conclusions can be interpreted from these frames? (Choose two.)

A. The network is performing slowly because 802.11n clients are already mixed with 802.11g clients.
B. The network is performing slowly because 802.11b clients still exist in the network.
C. The network is performing slowly because a wireless client is incorrectly configured, which results in RF interference.
D. Possible 802.11b wireless clients are located only in the AP cell radius where the sniffer capture was performed.
E. Possible 802.11b wireless clients could be located anywhere in the wireless network.

Answer: B, E

Question: 23

A wireless engineer is designing the wireless networking for a company with offices in two different locations. Which two regulatory bodies should they check to find the maximum EIRP allowed? (Choose two.)

E. Wi-Fi Alliance

Answer: B, D

Question: 24

After installing a Cisco 5508 Wireless Controller using the default settings, how often will the RRM update occur?

A. 30 seconds
B. 60 seconds
C. 300 seconds
D. 600 seconds
E. 3600 seconds
F. 7200 seconds

Answer: D

Question: 25

A customer has requested a single point of policy enforcement for LAN and WLAN. Which deployment model should be used?

A. converged
B. autonomous
C. FlexConnect
D. centralized

Answer: A

Question: 26

A customer has asked for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch. Which EtherChannel mode should be used on the switch to allow for the WLC to connect?

A. on
B. auto
C. desirable
D. passive
E. active

Answer: A

New Updated 200-355 Exam Questions 200-355 PDF dumps 200-355 practice exam dumps:


Facebook Comments