Success in Cisco Implementing Cisco IP Switched Networks 300-115 exam with the all-inclusive Cisco 300-115 exam dumps preparation material is offered with money back guarantee so either you embrace the success or get your money back because your success is the central focus. 300-115 exam practice test software is designed in a way that it gives you a chance of getting a clear picture of whole syllabus, exam pattern, practice of exam in simulated real exam scenarios and more than all evaluation of your learning independently with self-assessment feature.
|Full Exam Name||Implementing Cisco IP Switched Networks|
|Certification Name||Cisco Certified Network Professional Routing and Switching|
♥ Get Valid 300-115 Braindumps ♥
300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps:300-115 Exam Dumps (580 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Cisco 300-115 Braindumps:
Which two VLAN ranges can you add. modify or delete on a switch’? (Choose two)
A. 1 through 1001
B. 1006 through 4094
C. 1005 through 4094
D. 2 through 1001
E. 2 through 4094
Which Cisco technology provides network redundancy by combining two physically separate
switches to a single logical switch’?
Which two commands configure RSPAN to capture incoming and outgoing traffic on a single
interface’? (Choose two)
A. monitor session 1 source interface gigabitethernetl/0/2 tx
B. monitor session 1 destination remote vlan 910
C. monitor session 1 source interface gigabitethernetl/0/1 rx
D. monitor session 1 destination interface gigabitethernetl/0/2 rx
E. monitor session 1 source interface gigabitethernet1/0/2 both
Which feature is enabled automatically when you configure HSRP on an interface?
A. ICMP redirect messages
B. HSRP tracking
C. IGMP snooping
D. HSRP preemption
Which command do you enter to troubleshoot a misconfigured EtherChannel?
A. CORE-SW(config)#spanning-tree etherchannel guard misconfig.
B. CORE-SW(config-if)#spanning-tree guard root
C. CORE-SW(config-if)#spanning-tree loopguard default
D. CORE-SW(config-if)#spanning-tree etherchannel guard misconfig
Which statement about configuring an RSPAN session is true?
A. RSPAN supports, by default, the monitoring of Layer 2 switch protocols.
B. The same RSPAN VLAN is used for a RSPAN session on all the switches.
C. Only the source switch in a session must support RSPAN
D. At least one access port must be configured in the RSPAN VLAN
New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps:https://www.dumpsschool.com/300-115-exam-dumps.html