Cisco CCIE Data Center 400-151 Exam Dumps

Question No. 1

Refer to the exhibit.

Which two characteristics can you tell about the device connected on e1/1 from the output from the Cisco UCS CLI? (Choose two)

• A. The device supports Ethernet only
• B. This device supports FCoE
• C. The device is a B-Senries server
• D. The device is a C-Series server
• E. This device supports PoE

Question No. 2

In which location can device package logs be found?

• A. /data//logs
• B. /data/devicescrips//logs
• C. /var/sysmgr/tmp_logs//logs
• D. /var/logs/dme/log//logs
• E. /data/devicescrips/logs

Question No. 3

Which three commands must be run to enable support of adapter-fexon an interface on a Cisco Nexus Switch? (Choose three)

• A. switchport mode vntag
• B. feature-set adaper-fex
• C. feature-set virtualization
• D. feature fex
• E. feature adapter-fex
• F. switchport mode adapterfex

Question No. 4

Which option is required by atomic counters to be leveraged in troubleshooting endpoint connectivity?

• A. Endpoint must connect to different leaf switches.
• B. Endpoints must be different endpoint groups.
• C. Endpoints must be in different bridge domains.
• D. Endpoints must be in different VRFs.
• E. Endpoints must connect to the same leaf switch.

Question No. 5

Which two statements about UCS switch mode are true? (Choose two)

• A. Disjoint Layer 2 networks are supported only when the Ethernet switching mode of the fabric interconnects is configured for switch mode.
• B. Switch mode is the default Ethernet switching mode.
• C. Broadcast packets flood out of all ports except the port that it was received on.
• D. Server-to-server multicast and broadcast traffic is sent through all uplink ports in the same VLAN.
• E. Ethernet switching mode must be used only if the fabric interconnect is connected directly to a router.

Question No. 6

Which two statements about VXLAN are true? (Choose two.)

• A. VXLAN uses a UDP destination port of 4987.
• B. A VTEP is a virtual or physical device that maps end devices to VXLAN segments.
• C. Devices that terminate VXLAN tunnels are known as VTEPs.
• D. VXLAN adds an additional 32 bytes worth of headers.

Question No. 7

Which two parameters must be identical per interface while configuring virtual port channels? (Choose two)

• A. network access control
• B. Bridge Assurance setting
• C. maximum transmission unit
• D. Protocol Independent Multicast
• E. IP Source Guard

Question No. 8

Which three statements are considered best practice when configuring an NFS appliance port on Cisco UCS? (Choose three)

• A. If storage and servers are located in the same subnets, then the appliance port VLANs should be allowed on the upstream switch
• B. Cisco UCS supports Static and Link Aggregation Control Protocol port channels for appliance port configuration. However, no virtual port-channel support
• C. If storage must be accessed outside of the Cisco UCS domain, then the appliance port VLANsshould be allowed on the upstream switch
• D. Use of the same VLAN for multiple storage protocol traffic is highly recommended to conserve VLAN namespace use
• E. If storage is configured in active/passive mode and both fabric interconnects require communication to the same controller, then the appliance port VLANs should be allowed on the upstream switch
• F. Configuration of the VLAN tagging on the storage side and on the Cisco UCS side simultaneously is recommended

Question No. 9

Which three options are SDN Southbound protocols? (Choose three)

• A. API
• B. OVSDB
• C. OpenFlow
• D. Puppet
• E. PCEP
• F. VXLAN

Question No. 10

Which routing protocol is implemented between leaf and spine switches to propagate external routes within the ACl fabric?

• A. Intermediate System-to-lntermediate System
• B. Open Shortest Path First
• C. Border Gateway Protocol
• D. Multiprotocol Border Gateway Protocol

Question No. 11

You have been asked to review the loT migration plans for manufacturing plant. Which technology should take priority?

• A. Applications
• B. Sensors
• C. Security
• D. Ethernet Switches
• E. Wi-Fi Infrastructure

Question No. 12

Refer to the exhibit.

Which two statements are true? (Choose two.)

• A. The option failover is enabled on all the interfaces
• B. Interface vfc 1871 is pinned to fc interface 1/32 in fabric interconnect B
• C. Server 7 in chassis 4 has been associated with profile circuit
• D. To check the MAC address from server 7/4 interface eth 10. you can check the MAC addresses learned on veth 1866 on fabric interconnect B
• E. The server has total of six vNICs.

Question No. 13

Which statement about enhanced zoning is true?

• A. It cannot move back to basic zoning from enhanced zoning without a clean wipe and restore of the switches in the fabric.
• B. It does not support fWWN-based membership in the standard interop mode (interop mode 1).
• C. It provides a vendor ID along with a vendor-specific type value to uniquely identify a member type.
• D. Changes to the zoning database and subsequent distribution require reactivation of the zone set.

Question No. 14

‘GET/api/v1/Processes’ is a valid CPO REST call to retrieve all processes.Which two encapsulations are supported? (Choose two)

• A. HTML
• B. YAML
• C. JSON
• D. cURL
• E. XML

Question No. 15

Refer to the exhibit.

Which two features are enabled on the upstream switch? (Choose two)

• A. feature fcoe-npv
• B. feature npv
• C. feature fport-channel-trunk
• D. feature npiv
• E. feature fcoe

Question No. 16

Which OpenStack project, whose data can be used to provide customer billing, recourse tracking, and alarming capabilities across all OpenStack core components, is a component of the telemetry project?

• A. Ceph
• B. Ceilometer
• C. Heat
• D. Trove