Authentic 300 101 Questions

Question No. 1

Question on PPPoE ? (Choose Two)

• A. A PADI (PPPoE Active Discovery Initiation) broadcast signal is sent by the host to the remote devices
• B. A PADR (PPPoE Active Discovery Request) unicast signal is sent to confirm the remote device.
• C. A PADR (PPPoE Active Discovery Request) broadcast signal is sent by the host to the remote device.
• D. A PADO (PPPoE Active Discovery Offer) signal is sent by the remote device back to the host.
• E. A PADT (PPPoE Active Discovery Terminate) signal

Question No. 2

A network engineer wants to notify a manager in the event that the IP SLA connection loss threshold is reached. Which two features are needed to implement this functionality? (Choose two)

• A. SNMP traps
• B. threshold action
• C. MOS
• D. logging local
• E. Cisco IOS EEM

Question No. 3

Which two statements about Frame Relay point-to-point connections are true?(Choose

two)

• A. They use two DLCIs to communicate with multiple endpoints over the Frame Relay cloud
• B. The device can establish a point-to-point connection to the cloud without a DLCI
• C. Changing a point-to-point subinterface to a different type requires the device to be reloaded.
• D. They can operate normally without a DLCI map
• E. Each physical interface that extends to the Frame Relay cloud can support a single SVC.

Question No. 4

Which command sequence is implemented on a router to configure unicast reverse path forwarding in loose mode?

• A. interface GigabitEthernet0/0 ip verify unicast source reachable-via rx
• B. interface GigabitEthernet0/0 ip unicast source reachable-via loose
• C. interface GigabitEthernet0/0 ip verify unicast source reachable-via any
• D. interface GigabteEthernet0/0 Ip verify uncast source reachable-via all

Question No. 5

Refer to the exhibit.

Which statement describes the effect of this configuration on a Cisco router?

• A. The default router through 192.168.0.1 is used only when 10.0.0.1 is unreachable
• B. The default router through 192.168.0.1 is never used.
• C. The default through 10.0.0.1 used only when 192.168.0.1 is unreachable.
• D. The default route through 10.0.0.1 is never used.

Question No. 6

If you configure one router in your network with the auto-cost reference bandwidth 100 command, which effect on the data path is true?

• A. The data path changes for 10 Mbps links only
• B. The data path changes for all links
• C. The data path remains the same for all links
• D. The data path changes for 10 Gbps links only